We offer the RELIC in standard sizes listed below, but we can fabricate them to your custom length specifications granted it does not exceed the limits of practical safety! Follow up your purchase with an email explaining your needs and we will take care of you. If purchased with an axle, the axle bushings are included as well and can be modified to use metric axles should you need. The RELIC can be shipped with a standard 3/4" axle kit.
allowing stand-offs to be used when mounting your brake hardware. The bottom two holes on the leg gussets are 5/16 and 3/8 I.D. See our website for a shock or use your own.Īlso built into the RELIC are mounting points for a variety of aftermarket "Springer type" brake systems. Spring rate is up to your personal preference but we have found that 350 to 400 lbs is a great starting point for most bikes up to 500 lbs. The RELIC accepts most any performance mountain bike shock that are 180 to 200 mm (7.5" to 8" eye to eye) with a minimum 2 inches (25 mm) of travel. There are THREE different widths!! Narrow, Mid and Relic-X which is our widest!!! And wildest!!!! Use a Pro-One bottom bearing race with stop tab (Sold Separately) and don't worry about drilling and tapping holes. Adjust both with very little effort and switch back again when you are ready!Īccommodations for an internal fork stop have been provided. Let us provide the exact match.Our springers can be delivered raw metal (Standard)or color matched in either powder coat or epoxy paint, or chrome plated.There are so many innovations on this stunning front end! Not satisfied with your rake? No problem! Same goes for the fork length. Trying to color match your frontend to your frame? Ride height with rear wheel in place to ensure a proper fitĪ: Measure vertically from ground to the bottom most part of the neckī: Measure vertically from ground to center of the front axleĬ: Measure overall neck length including cups, bearings, and dust covers NOTE: Position the frame level with the ground and set to final Narrow Glide Springersįinish Options – Raw, Powder Coating or Chrome Available in either powder coat or color match paint.
Each Springer is shipped raw metal and comes with all hardware, including front axle, chrome springs, and stainless lower rockers. Every springer is custom built to order and calculated to give the best trail for your ride. The Executioner Springer frontends enable you to hurdle the wounded and trample the dead with a bulletproof ride. We produce 2 versions to choose from, a narrow and wide glide which allows for different style front wheels and hubs. Our Executioner Springers are handcrafted by machinist and bike builders, precision CNC machined and all TIG welded in-house.
0 kommentar(er)
